EMGLAB FORUM

EMGLAB FORUM >EMGLAB SOFTWARE

  Subject:   EMGLAB SOFTWARE
 
From:   M.GAUTHAAM Date:   23 Feb 2011 5:52 am  
Reply via e-mail to M.GAUTHAAM.  
  HELLO,
I AM NOT ABLE TO EXTRACT EMG SIGNALS THAT I COULD PLOT IN EMGLAB INTO MATLAB WORKSPACE SO THAT I COULD WITH THE SIGNAL IN MATLAB. IT WOULD BE VERY KIND OF YOU IF YOU COULD HELP ME IN THIS REGARD.

THANKING YOU IN ADVANCE..
  >> Reply to this message  

  Subject:   Re: EMGLAB SOFTWARE
 
From:   Kevin McGill Date:   22 Mar 2011 6:03 pm  
Reply via e-mail to Kevin McGill.  
  Hi Gauthaam,

The easiest way is to load the signal into EMGlab and then enter these commands in the Matlab command window:

>> s = emgsignal;
>> s = s.sig;

This will put the signal into the variable s.

Best,
Kevin McGill


M.GAUTHAAM wrote:
>HELLO,
> I AM NOT ABLE TO EXTRACT EMG SIGNALS THAT I COULD PLOT IN EMGLAB INTO MATLAB WORKSPACE SO THAT I COULD WITH THE SIGNAL IN MATLAB. IT WOULD BE VERY KIND OF YOU IF YOU COULD HELP ME IN THIS REGARD.
>
>THANKING YOU IN ADVANCE..
  >> Reply to this message  

sponsors:
Veterans Affairs Palo Alto Rehabilitation Research and Development Center
|
National Institute of Neurological Disorders and Stroke